BP6.Com

So I have noticed. I have two BP6 boards, both with cap problems. Cool thing is Abit has repaired one and it is on the way back to me. I plan to send the other one back and the sell it after it has been repaired. Oh, when I asked Abit to repair the board they told me they don't do that anymore. Then...

Yes, these temps are with a load. I'll probably replace the coolers because they are 3 or 4 years old and I don't want to worry about temp.

I appear to have other concerns.....(Capacitors!!!)

Hey guys, I recieved my working BP6 and got it running. I posted another question in the Processor area of this forum.

http://www.bp6.com/board/viewtopic.php? ... &highlight

I have two 366's running on my BP6. Currently they are set at 92mhz FSB at 5.5 multiplier with 2.1 core voltage. System has been running smooth for about 24 hrs. The temps. are reading: CPU 1 = 97F CPU 2 = 105F System = 101F Can I go any higher FSB and are my temps. ok? Also, if I try for 100FSB it ...

Yes, I believe they do. All the 366's I have say 128 SL36C and I thought that means sSpec SL36C and 128K L2 cache. I have ran one of them at 551 for 3 years straight without problem on a BE6 with a Slot 1 to 370 converter. The two I plan to use on the BP6 have the same specs.

Ok, I go with the 366's and if I fix my other board, I'll use the 500's there.

No, I haven't tried using an ISA card for boot-up. I'll look around the house and see if I have one. As for the cap, I have found one to be loose and installed VERY poorly. I ordered another BP6 so I have nothing to loose by trying to replace the loose cap, if I can find one. Not to jump off subject...

Acutally I have an update, I have found one capacitor ready to fall off. :shock: I can move the cap and see the pins on the bottom move around. I think it is a cap replacement gone bad. :cry: Now I have to decide to send it to httP://www.motherboardrepair.com for repairs, if possible. I don't know i...

I have recently aquired a used BP6 board and can not get it to boot. I hooked-up everything and nothing happens. When I remove the CMOS jumper the fans start moving, but nothing more, not even power light. The board stops when I re-install the CMOS jumper to the correct position. It will turn the fa...