so now i've been using the Speedfan for a while...it has the BP6 setup on the load from the web site, so i really suggest using it...also, it monitors the HDD temp., and you all know how good is that - if you had the HDD that went dead! btw, it's FREE software...
so here is the site: http://www.almico.com/speedfan.php
and the Voltage readout for my board is 3,2V...is that bad?
(all 3 slots are taken with 768MB of RAM)
Batch codes, RAM specs, BIOS settings, etc..
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 4 guests