Alright, I have a bp6 with a celemine 566 at 850 right now. I am using one stick crucial 256mb pc133 cl2, and one kingston valueram 256mb pc133, unknow lat. I cannot set the memory at anything other than 3.
The board has a cap soldered piggyback to one cap in between the two cpu sockets, along the top edge of the mobo. I have had no problems with this setup, along with an antec trupower 330watt.
Has anyone else had this kind of trouble? I have the RU bios also if that helps any. Late!
Ram timings help!
Ram timings help!
Dual Barton Mobile 1.8ghz
Venice 3000+ @ 2.6ghz
lots of BP6s and two VP6s all apart currently
Venice 3000+ @ 2.6ghz
lots of BP6s and two VP6s all apart currently
-
- Board Admin
- Posts: 1395
- Joined: Wed Jul 24, 2002 7:39 am
- Location: Lincoln, NE USA
- Contact:
Well, I certainly will try all that out. I just fixed a "the system has recovered from a serious error" infinite loop. Probably muck with the ram some tomorrow. The crucial stick is 256mb pc133 cl2, so it should have no problems at 100fsb cl2, but its running at 3 right now, along with the kingston stick.
Anyone know off hand what the kingston valueram pc133 is as far as latency? I know they use whatever flavor chips are plentiful when they need them. But it is pc133, so even if it was cl3, I would hope it would run at 2. The chips are elpedia, I can get a pic if it would help id it.
Thanks!
Anyone know off hand what the kingston valueram pc133 is as far as latency? I know they use whatever flavor chips are plentiful when they need them. But it is pc133, so even if it was cl3, I would hope it would run at 2. The chips are elpedia, I can get a pic if it would help id it.
Thanks!
Dual Barton Mobile 1.8ghz
Venice 3000+ @ 2.6ghz
lots of BP6s and two VP6s all apart currently
Venice 3000+ @ 2.6ghz
lots of BP6s and two VP6s all apart currently
-
- Board Admin
- Posts: 1395
- Joined: Wed Jul 24, 2002 7:39 am
- Location: Lincoln, NE USA
- Contact:
I did some brief searching and found that the Kingston ValueRam you are using is CL3. Doesn't look like you'll be able to go CL2.headseed wrote:... Anyone know off hand what the kingston valueram pc133 is as far as latency? I know they use whatever flavor chips are plentiful when they need them. But it is pc133, so even if it was cl3, I would hope it would run at 2. The chips are elpedia, I can get a pic if it would help id it.
Thanks!