Vcore problem

Grond · Post by **Grond** » Sat May 08, 2004 12:09 am

I have both Vcores set to 2.2. Sandra says they are both around 2.16 while motherboard montiro says cpu 0 is 2.16 but cpu 1 is 1.52. Cpu 0 has always run about 2 degress celsius hotter, right now they are at 43 and 41. Who do you think is right?

InactiveX · Post by **InactiveX** » Sat May 08, 2004 2:11 am

Have a look at this:

http://www.bp6.com/board/viewtopic.php?t=1251

Dave Rave · Post by **Dave Rave** » Sat May 08, 2004 3:39 am

2.16 is close enuff for 2.20
cpu 1 often will show the VTT unless you set the prog properly.
std fans will give about 3-7 degrees difference. I got them matched, but it took huge copper coolers with good fans.

no prob so far.

unless you're overclocking, they will run at 1.85v, meaning less damage and cooler.

Grond · Post by **Grond** » Mon May 10, 2004 1:14 am

Well I tried changing the setting to show Vcore but it didn't seem to work. After learning its showing the VTT though I decided I preferred that.

Holodeck2 · Post by **Holodeck2** » Mon May 10, 2004 2:32 am

no need to worry if they swing a fraction from where they're supose to be.
the inaccurate measurements are caused by temp changes, electronic interfearance, etc

davd_bob · Post by **davd_bob** » Tue May 11, 2004 1:12 am

Grond,
have you tried running lower vcore on those cpus?
unless you are seriously oc'ing you can probably drop to 1.9v or lower.