Hi!
This week i modded my bp6 to use P3's with Neo 370 adapters. Everything went fine, but my system wasn't very stable, so i changed my ec 10 resistor to a 1200microF but this still doesn' help, i had many system crashes. Then i did the Yoichiro's Ultimate VTT mod but i forgot to turn off the bios battery. After the mod i wanted to start my computer, but i doesn't boot and i don't get any output on my screen. Could it be, that i destroyed my bios ?? Is there anyway to get my bp6 working again, or must i buy a new one ??? Thanks for your help in advance.
Bye, iSDn.
PS: Excuse my bad english.
Problems after P3 mod....
-
- Posts: 90
- Joined: Wed Aug 21, 2002 6:19 pm
- Contact:
Hi!
I'm sorry, because myreply took so long but i'm without internet access since a few months. My problem is solved, i made a stupid mistake. I soldered the ground cable of the Regulator on my printer port and not on the atx ground...shame on me. Now everything is running fine. Thanks for your help!!!
Bye, iSDn!
I'm sorry, because myreply took so long but i'm without internet access since a few months. My problem is solved, i made a stupid mistake. I soldered the ground cable of the Regulator on my printer port and not on the atx ground...shame on me. Now everything is running fine. Thanks for your help!!!
Bye, iSDn!