I am assuming that you are looking for the HPT366 drivers. Here's a link to the current Win9x driver set from HighPoint's WEB site:
http://www.highpoint-tech.com/366_98_125.zip
Driver for PCI Mass Storage Controller
-
- Board Admin
- Posts: 1395
- Joined: Wed Jul 24, 2002 7:39 am
- Location: Lincoln, NE USA
- Contact:
-
- Board Admin
- Posts: 1395
- Joined: Wed Jul 24, 2002 7:39 am
- Location: Lincoln, NE USA
- Contact:
A couple comments...rootgap wrote:The USB card is in slot 5.
Cards in slots:
1- Blank, next to my 64meg AGP card - Nvidia GForce4-MX440
2- Yamaha Sound Card
3- Blank - USB output connections (4 each)
4- NIC
5 - USB 2.0 Interface Card
Also in the BIOS setup there is a setting for assigning IRQ's to USB should this be Enabled or Disabled?
rootgap
Make sure you are using the RU BIOS version.
PCI slots 4 and 5 share the same bus master control signal. You can't install two PCI cards that will occupy the same the bus master signal into both PCI slot 4 and 5 at same time.
The Assigned IRQ For USB option should be set to Enable.